• The race begins when the operator presses the START BUTTON. The Christmas Tree counts down with three YELLOW lights along with three corresponding short tones.
• The GREEN lights illuminate with a corresponding single longer tone signaling the start of the race.
• Riders enter the flumes and begin racing. The signals change to a RED X indicating the slide is occupied and a race is in progress.
• At the same time as the GREEN light start, the RACE TIMERS at the finish area clear and begin counting up with the elapsed time.
• AccuLogic™ sensors located near the end determine the finishing point and stop the timers when the racers pass. Timers display elapsed time (00.00) and finishing place (1-X).
• Signals return to a YELLOW BALL immediately or can change after a delay time that is adjustable. The change in color resets the system allowing for the next race.
POWER REQUIREMENTS:
120V – 5 AMPS at Start Tower and Finish Line Gantry
EQUIPMENT LIST:
1 LL-202 Christmas Tree Start light per 4 lanes
1 LL-300 Upper Control Box (20x18x10)
1 LL-308 Lower Control Box (20x18x10)
1 LL-200 AccuLogic Signal Emitters per 2 lanes
1 LL-205 AccuLogic Signal Receivers per lane
1 LL-700 Waterproof access port per 2 lanes
2 LL-502 Polycarbonate lenses per lane
1 Lot Quick Disconnect Cables
1 Lot Installation Hardware and Brackets
1 Finish Line Gantry truss System
